Teaching tool: the Flow Lab physics is the V1 flow model (stock goBILDA StarterBot, model.xml from 2026-11-04). It is historical and does not show the current robot.
Current robot: V7 (2026-11-17, 4-pocket windmill). Open the V7 page · FLOWER D3 · Playbook. Note: this Flow Lab runs the older V1 flow model (historical, for teaching). It is not the V7 robot.
Earlier study (stock V1 robot, before V6/V7). Both balls now run the whole chain from the floor: intake, deck, windmill, Hogback shot. In the model, from the floor, POLLEN shoots in 9 of 9 and NECTAR in 8 of 9 runs (3 sizes x 3 sideways offsets); balls up to 130 mm off-centre also get in. Changes from stock (teal = new rail parts): curved rail round the windmill, a low lead-in skirt in front of it, the left lane wall 12 mm out, front corner wheels on, roller bar 16 mm lower, the ribbed 72 mm feeder wheel at the foot of the ramp (green, from the V4 CAD; speed servo assumed 100 rpm), and the V4 carriage, which now moves to the POLLEN or NECTAR pose by itself for the ball you spawn (tick box in the V4 carriage section). The largest NECTAR straight down the middle is the one known failure. Every input is tagged measured, source or assumed.
Earlier study (V1/V4/V5-era, stock robot and earlier CAD). It does not show the final V6 or V7 designs: see the Final V6 / V7 tab.
Loading physics and robot model (about 16 MB the first time)...