Historical page (2026-11-07). It shows the old V5 FLOWER tube with a four-bar lift. It was replaced on 2026-11-17 by the approved design D3: a short, wide, slick rear tube whose spout rolls 40 degrees at fire. See FLOWER D3 and the current robot, V7.

FLOWER tube: servo-lifted tube that feeds the flywheel shot into the FLOWER

Side view of the BIOBUZZ StarterBot V5 (y toward the rear, z up). The flywheel shoots as it always does; a funnel on the tube catches the ball, an arch turns it over, and it drops into the top of the FLOWER (opening 4 in at 21.5 in). Two servos lift the tube on a four-bar linkage; a third rolls the arch flat for the 18 in start cube. Everything here comes from the V5 Fusion model and the ball simulation in sim_study/flower.

robottube P + funnelarch Qcrank / linksize limits

Rule checks, measured on the V5 CAD

Ball transit, flywheel to spout (simulation)

Drop into the FLOWER, spout tip 37 mm above the top ring

Spout height versus alignment tolerance (NECTAR)

What is and is not shown