Full path (V7): floor, intake, windmill, gate and blade, Hogback, HIVE

One cycle of the V7 robot end to end in the MuJoCo chain sim (the model of the 2026-11-15 build, 4 balls per load): the ball tracks below are recorded from the same simulation that the Flow Lab tab runs. The shot is then flown with air drag into the HIVE opening. These are model results with assumed contact parameters, not measured rates.

Top view (x across, front of the robot at the bottom): windmill and vanes rotate, the four balls ride in the pockets; coloured ring = the ball you selected. Lower view: side section of the robot (projected hulls) and the flight of the selected ball with air drag (Cd 0.47) to the HIVE opening; HIVE walls and rebound are not modelled in this view (the Flow Lab tab does model the walls).

This ball

This cycle

Stage by stage, all baked cycles (HIVE at 1.3 m)

Exit state of the shot

Where the losses are

What is and is not shown, and what is uncertain